Polycom vvx 1500 - error application is not present

[Jorge_Sepúlveda]

Hello, I hope this formum help me!

Today I received a dead VVX1500 videophone.

It died by the following:

 - Someone tried to upgrade using the Technical Bulletin 53522.

 - The videophone tried to download the files from the FTP server, but shows this message: "BootBlock failed to flash all times"

 - I received the VVX with the issue. Checking the about page I discovered that it has the bootROM 4.3.0.

I think that it fails because the 'Upgrade' was done with an earlier version of SIP and bootROM. 

I have read some FAQ. And I have some questions:

If my phone is in a Reboot Loop, how can I check this info "Before you can successfully install UC Software 4.x.x onto phones running Polycom® UCS released prior to version 4.0.0, you must perform a required upgrade procedure using the Polycom® Upgrader 4.0.0 Utility."? I don't know what version it had before the upgrade.

Reload the software will recover the phone?

I will preciate any help, or comment.

[SteffenBaierUK]

Hello Jorge,

welcome to the Polycom Community.

The community's VoIP FAQ contains this post here:

Sep 27, 2012 Question: I get the error Message “application not present / found” on my phones screen

Resolution: Please check => here <=

Above explains what this message means.

Oct 7, 2011 Question: How can I setup my Phone / Provisioning / Download Software?
Resolution: Please check => here <=

Above explains how to get the software on the Phone. I would suggest you use UCS 4.0.3 Rev F

Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.

Best Regards

Steffen Baier

Polycom Global Services