Hello - we recently moved several Polycom VVX 250 phones to a new build (previously used in another office). They boot up just fine but when we go to place a call, we have a dial tone, and the screen says 'SIP'. When we try to dial a number, a jumble of number and letters appear on the screen - instead of just a phone number.
Not sure if SIP is a mode that it's in? Went through the admin menu and not sure what setting to change to get it working/dialing like a regular phone.
Hello @KirbyDo ,
Welcome to the Poly Community.
Both the communities Must Read First or Read 1st and if available the FAQ reference the basic minimum information a new or follow-up post should contain.
This ensures the questions having to be asked are limited and any new or follow-up post contains the right amount of details to ensure any voluntary participant within the community does not spend additional time chasing basic information.
Unfortunately, your post fell a bit short of the above-explained requirements and we kindly ask you, therefore, to ensure to read these sections and ensure a reply (not Edit!) provides as much detail as possible
Please ensure you familiarise yourself with the FAQs listed in my signature for your convenience.
The best and quickest way forward is to contact our Support organisation as the community is run by volunteers only.
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
If official support is required please check how to phone or open a case here----------------