• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
HP Recommended

Hi all,

we have a problem with the systems HDX7000/8000/900x ver. 3.0.3.1-19040  and  3.0.4-20259.

Scenario:
Scopia400 RADVISION MCU ver. 5.7.2.9.10.
Service-Video MCU - Portocol H.261-H.263-H.264 384Kbps - and resolution up to CIF.

 

When a system HDX with ver. 3.0.3.1-19040  or  3.0.4-20259 333 comes into meetings, endpoint does not send the video.
while if the same system hdx comes with ver. 3.0.2.1-17007 or 3.0.0.2-13047 or 2.6.1.3-5205 video works.(NO FW)

 

Another test, same Service on MCU removing the protocol H264. The video works fine.

Or if in the same Service select bandwith 768Kbp and resolution up to 720P with H.264 the video works fine.

 

The problem seems to be linked to the component h264 and CIF. With older versions was fully functional.

 

I found some other posts about having a basic mode turned on, but in recent firmware the basica mode is missing. What we did find, was that diagnostic mode was turned on, and this disabled h.264.
Once we disabled this we had everything working properly. But only H261 and not H264. In this case for all call to be made H.264 are disable.

 

I need to make call H.264 and CIF for Standard Definition. Of course everything is OK if I make a P2P calls "forced" this protocol and resolution.


Can you help me?

Thanks

1 REPLY 1
HP Recommended

Hello Nepal99,

 

welcome to the Polycom Community.

 

Thank you for bringing this to our attention but the correct procedure should be that you contact your Polycom Reseller and/or Polycom Support directly as troubleshooting an issue of this kind is not within the scope of the community.

 

Feel free to update this post with a resolution or some feedback once you worked through the correct escalation channels.

 

Best Regards

 

Steffen Baier

 

Polycom Global Services

------------------------------------------------
Notice: I am an HP Poly employee but all replies within the community are done as a volunteer outside of my day role. This community forum is not an official HP Poly support resource, thus responses from HP Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge.
If you need immediate and/or official assistance for former Poly\Plantronics\Polycom please open a service ticket through your support channels
For HP products please check HP Support.

Please also ensure you always check the General VoIP , Video Endpoint , UC Platform (Microsoft) , PSTN
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.