Hello,
Support for CISCO TIP was introduced with firmware version 3.0.2 and an option key is required.
From the 3.0.2 release notes:
Support for Telepresence Interoperability Protocol (TIP)
HDX systems with version 3.0.2 software and the TIP option key can
interoperate with TIP endpoints. When the TIP option key is installed, the
following changes are made automatically:
• The 1024 setting is enabled on the Call Speeds screen.
• A TIP setting is displayed and enabled on the Call Preference screen.
• A SIP setting is automatically enabled on the Call Preference screen.
• SIP (TIP) Calls settings appear on the Preferred Speeds screen.
HDX Systems
TIP is supported on the following HDX systems:
• Polycom HDX 4500
• Polycom HDX 7000 HD with Hardware Version C
• Polycom HDX 8000 HD with Hardware Version B
• Polycom HDX 9006
TIP Support Notes
• Only TIP version 7 is supported.
• In a TIP call, only XGA content at 5 fps is supported in the Content in
Connector (VGA or DVI). USB content from the Polycom Touch Control
and People+Content IP is not supported in TIP calls.
• HDX systems cannot host multipoint calls while in a SIP (TIP) call.
• SIP (TIP) calls must connect at a call speed of 1 Mbps or higher.
For more information about Polycom support for the TIP protocol, refer to the
white paper Polycom Enhances Its Portfolio with Support of Telepresence
Interoperability Protocol (TIP) and Polycom Unified Communications Deployment
Guide for Cisco Environment
Here is the link to the deployment guide, page 28 contains a list of all the supported products.
http://supportdocs.polycom.com/PolycomService/support/global/documents/support/setup_maintenance/pro...
