HDX 7000 multipoint camera control

Occasional Contributor

HDX 7000 multipoint camera control

Hi Board members - newbi here - i have an HDX 7000 with a multipoint license.  If i am on the HDX that is hosting the multipoint call, how can i control ALL far cameras?  I can control one but not the other two.   HMMMMM

Message 1 of 4
Polycom Employee & Community Manager

Re: HDX 7000 multipoint camera control

Hi Blueace,


In a multipoint call, you are only able to control the active speakers camera.


On the screen, it will be the site highlighted in a yellow box.


Unfortunately, you are not able to control all of the sites cameras at the same time.

Best Regards,

Please ensure you always check the FAQ's.

Please remember, if you see a post that helped you, and it answers your question, please mark it as an "Accept as Solution".

This forum reply or post is based upon my personal experience and does not reflect the opinion or view of my employer. Poly employee participation within this community is not mandatory and any post or FAQ article provided by myself is done either during my working hours or outside working hours, in my private time, and may be answered on weekends, bank holidays or personal holidays.
Message 2 of 4
Occasional Contributor

Re: HDX 7000 multipoint camera control

Thanks so much for the info - I'm new to these systems and the documentation on the web site is a bear to navigate through.  Thanks Again!

Message 3 of 4
Polycom Employee & Moderator

Re: HDX 7000 multipoint camera control

Polyschmertz is correct there is no way to do this via codec internal multipoint. The only way to perform this task is utilizing an RMX after the Personal Conference Manager has been enabled. The associated Admin guides have the required information on how to set this up.
Message 4 of 4