X50: UC 3.5.0
G7500: 3.5.0
Trio C60: 7.1.1
Our standard config is an X50 w/a C60 controller and just recently I happened to notice that if I had device mode enabled and I connected an X50 to a PC via USB there would be a prompt on the C60 to enter BYOD mode (see attached photo), This was great because it gives us the flexibility to use other UC tools. The issue that I am having is that I do not get the same prompt when I use a G7500, in fact there is no prompt at all. If the system is connected to a touchscreen display then device mode can be initiated by swiping left. I performed a factory reset and started from scratch and there was no change. Is there something that I am missing or is this not an option on the G7500? I don’t see any reason why it shouldn’t work, it's essentially the same software.
Thanks,
James
Solved! Go to Solution.
Seems to be performing better after reinstalling UC 3.5.0-344025.
#fingercrossed
Hello jbass@srcinc ,
Welcome back to the Poly Community.
Is this in Zoom provider mode or Poly mode? In order to get an official answer please raise a ticket with our support organization.
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
Best Regards
Steffen Baier
If official support is required please check how to phone or open a case here
----------------Zoom provider, Works w/an X50 & C60 but not a G7500 & C60.
Thanks
Service Request Number 1-23110610261
Hello jbass@srcinc ,
My colleagues most likely will contact you but is device mode enabled in the G7500?
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
Best Regards
Steffen Baier
If official support is required please check how to phone or open a case here
----------------Is device mode enabled in the G7500? Yes