Hello,
Does anyone know if it's possible to make a direct cal between a Polycom HDX 8000 HD and a LifeSize Team 220?
If we start a call, we get audio but no video. Is there a way to force video between these two endpoints? Perhaps force some protocol or resolution?
We aren't registered on any MCU or other system; we call eachother directly by calling an IP address.
Thanks,
Ruud van Strijp
I have called between the two vendors often. Is it possible that your HDX is set in Basic/Diagnostic mode ? That could cause this issue. Are both systems able to call to a known test site (Like 71.14.2.157 VTCTest) successfully) ?
Gary M
If i have understood the problem correctly you both systems have tried to call eatch other. Does both system fail to get picture?
Or is it just one of them? Are you connect on the same network?
It is worth ensuring that both HDX & T220 are on their latest vendor recommended firmware.
We have a Lifesize vendor in our group & have found interoperability issues introduced by both parties when firmware gets out of sync.
Pete
here here to PeteT - latest software versions on both as there was an interop issue regarding media a few versions ago.
Then you'd need to verify against another system, or test system - there is not reason Lifesize and Polycom can't talk to each other.
Thanks sharps, whilst Gary M & others are talking about test systems we've an old VSX7k on 89.105.107.135 which is on 24/7/365 & tested daily. Never mind the quality feel the width. Video can be poor but it'll help prove connectivity.
Hi there
I too have issues calling from a Lifesize unit - albeit one registered in their Cloud service and calling a HDX Polycom 8000 HD
This happens whatever i use - soft client or physical codec - we get audio but no picture
Cannot be our firewall setup as we have also tried different connections - Fibre, SDSL, 4G & ADSL all giving same results
#what we use is a Lifesize Icon 600 and Lifesize Cloud app on our PC/Mac/iPad, same result calling an HDX 8000 HD Polycom unit
Any ideas ???
WR
Anil